Three major problems in packaging machinery solutions


Packaging machinery has a variety of classification met […]

Packaging machinery has a variety of classification methods. According to the function can be divided into single-function packaging machine and multi-functional packaging machine; according to the purpose of use can be divided into the packaging machine and packaging machine; according to the packaging can be divided into special packaging machine and general packaging machine; according to the level of Automatic Cake Making Machine is divided into semi-automatic machine And automatic machines.

Mainly introduce the following points:
1.What is the reason that the shrinking machine is heating up slowly or cannot be raised to a higher temperature (above 160 degrees Celsius)?
Answer: The heater's line is the main power line through a magnetic switch and then to the heating pipe, so you should first detect whether the magnetic switch contacts are normal. If the line does not pass one of the phases, the above phenomenon will occur. If the magnetic pick-up switch is normal, check the meter again to see if the ohms of each phase and the machine are the same. If normal should be a short circuit. If all phases are on but the line or heater is still abnormal, the heater must be replaced.

2.The equipment in the work of film material is easy to offset and can not normally feed how to adjust?
Answer: In the case of film offset in the equipment, if the adjusted film roll position and tension balance bar are invalid, the problem can be solved by adjusting the angle of the upper triangle. If the upper layer film material deviates from the clamping chain, the upper triangular plate can be adjusted clockwise; the following layer film material is offset from the clamping material chain, and the upper triangular plate can be adjusted counterclockwise.

3.The packaging of 6 bottles of packaging bundles, the electric eye can not detect the packaging, the machine is easy to cut into the packaging, how to adjust?
A: The gap between the bundles of the bottles will affect the detection of the electric eye. At this time, the horizontal electric eye detection angle can be adjusted to be an oblique angle. After adjustment, the probability of detecting gaps in the package by the electric eye can be reduced, thereby avoiding chaos in the work.